Adjusting The Buttonhole Width And Density; Double Layer Buttonhole - Janome 8048 Manual De Instrucciones

Adjusting the buttonhole width and
density
a a a a a Adjusting the buttonhole width
Press the mode selection key
width adjusting mode.
Press the Down(–) key to decrease buttonhole width.
Press the Up (+) key to increase buttonhole width.
The buttonhole width can be varied from 2.5 to 7.0.
q Narrow buttonhole (2.5mm wide)
w Wide buttonhole (7.0 mm wide)
s s s s s Adjusting the buttonhole stitch density
Press the mode selection key
length adjusting mode.
Press the Down (–) key for denser stitch.
Press the Up (+) key for coarser stitch.
The stitch density can be varied from 0.2 to 0.8.
The LED display does not show the sewing step when
the adjusting mode is selected. After the buttonhole
sewing is finished, LED will show

Double layer buttonhole

To make a solid and sturdy buttonhole, sew another
layer of buttonhole over the previous one.
After the buttonhole is finished, simply depress the
foot control again.
a a a a a Do not raise the foot or reselect the pattern.
The machine will sew another buttonhole in the
following order and stop automatically:
s s s s s Straight stitching in reverse to go back to the
starting point.
d d d d d Front bartack and left row
f f f f f Right row
g g g g g Back bartack and locking stitches at the end
All manuals and user guides at all-guides.com
to enter the stitch
to enter the stitch
.
48
a a a a a
q
〜
s s s s s
a a a a a
s s s s s
d d d d d
f f f f f
g g g g g
w