Accessories Installation - GET ECULMB RACE KIT Guia De Instalacion

GET ECULMB INSTALLATION
1.
Before installing GET
ECULMB unit use a zip
tie to keep it firm while
riding: pass the zip tie
under the OEM harness.
Connect GET ECULMB
unit to the OEM loom
connector and tighten
the tie bundling together
GET ECULMB connector
with the harness below.
2.
Install other GET accessories, e.g. GET Map Switch
and GET WiFi-COM (see section E. ACCESSORIES
INSTALLATION).
3.
Re-install the seat. Pay attention that GET ECULMB,
once the seat is installed, is well positioned and does not
collide with the seat.
EN 10
E. ACCESSORIES INSTALLATION
MAP SWITCH INSTALLATION
REMEMBER TO WORK UNDER SAFETY CONDITIONS
AND TO KEEP THE ENGINE TURNED OFF.
1.
Install GET Map
Switch to the handlebar.
2.
Connect MAP Switch
faston terminals to the
MAP Switch expansion
cable faston terminals.
3.
Connect the
expansion cable to the
"AUX" connector of the
ECULMB unit.
WIFI-COM INSTALLATION
Install the WiFi-COM by following the dedicated manual.
ATTENTION: After the installation, check that the wiring
does not obstruct the free movement of the handlebar in
both directions or interfere with the moving components
of the motorcycle (e.g., transmission) or with the rider
(e.g. the boot area).
ECULMB
EXPANSION
CABLE
11 EN