Assembling The Equipment - Movement TOURS Manual Del Propietário

ASSEMBLING THE EQUIPMENT

CAUTION!
Before starting the installation of the equipment, it is necessary to pay
attention to the following precautions:
•Make sure that the packaging is not damaged and that the parts and
components of the equipment are not defective.
•It is recommended that the equipment be unpacked at the place where it will
be assembled.
•The assembly area should be clean.
•The floor must be flat and level to prevent equipment instability.
•The space around the equipment should be clear, as described in this Manual
(see Operational Instructions Chapter).
•It is recommended that the equipment be mounted away from moisture and
away from sunlight in order to avoid damaging the electronic parts of the
equipment.
• Be sure to lift all parts included in the boxes. Check the component list for a
complete count of the number of parts included for correct assembly.
•The purpose of the icons is to instruct the user on which tool to use, how
many people to assemble or to tighten the screws in a given step.
In order to assemble the equipment, the following tools are needed:
TOOLS
Fixed
wrench
Philips
Screw threader
wrench
medium torque
SPACER
We recommend that for the safety of the
users the equipment be used in an area that
is not frequently used based on the figure to
the side. The access and exit area can be
common between the oars used.
Assembly by two
Allen
recommended
M5
M6
50%
Don't fully tighten
people is
TABLE OF SPECIFICATION OF SCREW
Diameter [mm]
91 cm
16
ICONS
100%
Fully tighten
the bolts
the screws
TIGHTWINING TORQUE
Torque [N.m]
M6
9-12
M8 22-29
M10 45-58
91 cm