Charging Process; Switching On/Off - Heiniger StyleMini OT14 Manual De Instrucciones

3 Preparation
3.1 Changing the mains plug adapter
The appliance is supplied with a mains plug adapter 9. Other mains plug adapt-
ers can be ordered from the customer service centre (see service address on the
back of these user instructions).
WARNING!
Use only the original mains plug adapters 9.
Pull the power supply unit 7 out of the power socket before you
change the mains plug adapter 9.
Ensure that the power supply unit 7 cannot be plugged in again during
cleaning.
NOTE: ensure that you do not bend the small pins on the power supply unit 7.
1. Hold down the release key 8 while pulling off the
mounted mains plug adapter 9.
2. Insert the required mains plug adapter 9 into the
power supply unit 7. Ensure that the release
key 8 is located at the top and audibly clicks into
place.
3.2

Charging process

The appliance is not yet ready for operation when delivered.
Before you plug the trimmer into the power socket, check that the mains voltage
corresponds to the voltage specified on the type plate.
Before first use, the appliance should be charged for 2 hours.
"Overcharging" the appliance is not possible.
WARNING!
Before plugging in the plug-in power supply device 7, check that
the voltage of the power socket corresponds to the specifications
on the type plate.
– Insert the plug-in power supply device 7 into a power socket.
– Place the charging station 2 on a level surface.
– Ensure that the on/off switch 4 is set to 0 during charging.
– Place the appliance into the charging station. It positions itself automatically
and starts charging. The green charge status display 3 flashes during the
charging process. When the battery is fully charged, the charge status display
will be lit continuously.
4 Operation
4.1 Switching ON /OFF
– Image A: in order to switch the appliance on, push the on/off switch 4 forwards.
– In order to switch the appliance off, push the on/off switch to position 0.
ENGLISH 17