Initial Testing; Maintenance; Disposal; Additional Information And Contact Details - Roger Technology B71/BCHP Instrucciones Y Advertencias Para El Instalador

7

Initial testing

Disconnect from the mains power supply. The LED DL3
should extinguish.
Perform a complete open manoeuvre and a complete
close manoeuvre and check that the installation
functions correctly under battery power.
Reconnect to mains power and check that the LEDs
DL1 and DL3 illuminate.
8

Maintenance

Perform scheduled maintenance every 6 months.
Check cleanliness and function.
If the unit contains dirt, moisture, insects or other
foreign matter, disconnect from mains power and
clean the board and the housing.
Repeat the initial installation test procedure after
cleaning.
If any corrosion is found on the printed circuit board,
evaluate if it is necessary to replace the board itself.
Check battery charge by performing a complete open/
close manoeuvre and measuring the output voltage
from the batteries.
A healthy battery will not drop below 22 VDC during
operation.
Replace the batteries at least every 3 years.
9

Disposal

This product may only be uninstalled by
qualified technical personnel, following
suitable procedures for removing the
product correctly and safely. This product
consists of numerous different materials.
Some of these materials may be recycled,
while others must be disposed of correctly
at the specific recycling or waste management
facilities indicated by local legislation applicable for
this category of product.
Do not dispose of this product as domestic refuse.
Observe local legislation for differentiated refuse
collection, or hand the product over to the vendor
when purchasing an equivalent new product.
Local legislation may envisage severe fines for the
incorrect disposal of this product.
Warning! Some parts of this product may contain
substances that are harmful to the environment
or dangerous and which may cause damage to the
environment or health risks if disposed of incorrectly.
10
10
Additional information and
contact details
ROGER TECHNOLOGY is the exclusive proprietor
holder of all rights regarding this publication.
ROGER TECHNOLOGY reserves the right to implement
any modifications without prior notification. Copying,
scanning or any alterations to this document are
prohibited without express prior authorised from by
ROGER TECHNOLOGY.
ROGER TECHNOLOGY CUSTOMER SERVICE:
business hours: Monday to Friday
08:00 to 12:00 - 13:30 to 17:30
Telephone no: +39 041 5937023
E-mail: service@rogertechnology.it
Skype: service_rogertechnology
11

Declaration of Conformity

I the undersigned, as acting legal representative of the
manufacturer
Roger Technology - Via Botticelli 8, 31021 Bonisiolo di
Mogliano V.to (TV)
hereby DECLARE that the appliance described below:
Description: Battery and battery charger
Model: B71/BCHP
Is conformant with the legal requisites of the following
directives:
– 2006/95/CE;
– 2004/108/CE;
– 2011/65/CE;
and that all the standards and/or technical require-
ments indicated as follows have been applied:
EN 61000-6-3;
EN 61000-6-2
Last two figures of year in which marking was applied
| 14.
Place: Mogliano V.to
Date: 11-04-2014 Signature