Environmental Protection; Troubleshooting - Worx WG163E Manual Original

2. (See Fig. L)
Your grass trimmer is equipped with a Command Feed
System. Just press the button while the machine is
running, new line will feed out and then stop when you
hear the 'clattering' noise of the new line being cut. The
motor stops briefly when the Command Feed button is
pressed, and restarts when released. This process enables
the machine to automatically feed out new line.
3. MANUALLY FEEDING THE LINE (See Fig. M)
Press and release manual line feed button (14), whilst
gently pull out the lines until the lines reaches the line
cutter.
If the line extends past the line cutter, too much line has
been fed out.
If too much line is fed out, remove the cutting head cover
and rotate the spool anti-clockwise until the line is at the
desired length.

TROUBLESHOOTING

The following table gives problems and actions that you can perform if your machine does not operate correctly.
WARNING: Switch the machine off and remove the battery prior to any troubleshooting.
Problems
Trimmer fails to operate.
Trimmer runs
intermittently.
Excessive vibrations/
noise.
Cutting time per battery
charge too short.
Machine does not cut.
Continuous lighting
of the battery charge
indicator.No charging
procedure possible.
2-in-1 Grass Trimmer/Edger
Possible Causes
Battery discharged.
Battery too hot/cold.
Motor is broken.
Internal wiring of machine damaged.
Motor is broken.
Battery not fully charged.
On/Off switch defective.
Machine defective.
Line spool is not wound well.
Battery has not been used for long period or
only charged for short term.
Grass too high.
Battery defective.
Line broken.
Battery not fully charged.
Motor is broken (speed is too low).
Grass entangled around cutting head.
Battery not (properly) inserted.
Battery contacts contaminated.
Battery defective.
MAINTENANCE
After use, disconnect the battery from the tool and check
for damage.
Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts in your
power tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always store
your power tool in a dry room temperature location. Keep
the motor ventilation slots clean. Keep all working controls
free of dust.

ENVIRONMENTAL PROTECTION

Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities or
retailer for recycling advice.
Corrective Action
Recharge battery; also see
the content in charger manual.
Allow to cool/warm.
Contact Service Agent.
Contact Service Agent.
Contact Service Agent.
Recharge battery.
Contact Service Agent.
Contact Service Agent.
Rewind the line. See "MANUALLY
WINDING THE LINE" (Fig. O1, O2, O3, O4).
Recharge battery; also see
the content in charger manual.
Cut in stages.
Replace the battery.
Replace the line.
Recharge battery; also see
the content in charger manual.
Contact Service Agent.
Remove grass.
Properly insert battery into battery
charger.
Clean the battery contacts or replace the
battery.
Replace the battery.
15
EN