Charging The Battery Pack - CAMPAGNOLA T-REX 160-240 Manual De Uso Y Mantenimiento

CAUTION!
Remove the battery from the tool before performing any work on it. Injury hazard is still present in case of involun-
tary operation.
Perform the following operations in order to fill the oil tank:
 Clean the area around the cap (19), in order to prevent dust, chips and dirt from entering the tank (18).
 Unscrew the oil cap (19) and fill the tank (18) with biodegradable chain oil up to approximately 1 cm from the upper
edge; then close the cap.
IMPORTANT!
Make sure that there is a lot of oil on the chain during use. Regularly check the oil level in the tank (18)
which must never drop below the transparent zone and top up if needed.
If the chain is operated without oil, the chain and the bar will wear rapidly and the service life of the tool will
be reduced.
4.1.4

Charging the battery pack

Connect the battery (21) to the charger (23) and the latter's plug to the power socket; do not use any extension cords
because they are potential sources of electrical risks.
The LED lights (24) of the battery charger light up red during charging and turn green when the battery is fully charged.
Each charging connector (25) has a corresponding indicator on the charger.
The batteries are charged sequentially, not simultaneously
The LED indicator (24) is red during charging and turns green when charging is completed.
Charging with three connected batter-
ies:
when the first battery is charged, the
corresponding LED (24) turns green
and charging of the second and then
third battery begins.
Page 42 Use and maintenance manual – Instructions
Original instructions Rev.: 00, Date 11/04/2022