Back Support Adjustments - Permobil Compass Power Mount Hardware Operación Manual

Back Support Adjustments

Using the adjustable support features on Acta-Series back supports. All support systems can be adjusted for changes
in condition at any time.
Using Moldable Stays on all ACTA-BACK and ACTA-EMBRACE
back supports:
Rear view, showing Moldable Stay pockets
(ACTA-BACK shell)
WARNING: The bottom edge of the Moldable Stays MUST
reach the bottom of the pocket and MUST rest against the back
support shell. If they do not, they may push through the back
shell opening and will NOT provide the intended support.
1 With the user seated, identify the gaps between them and
the back support or areas that require positioning.
Suggestion: Use the moldable stays in an offset placement to
accommodate for rotation.
2 Unzip the top of the cover and remove the moldable stays
from the inner pockets.
3 Shape the moldable stays with your hands or with a firm
surface. Note that the black end is in the bottom when
shaping.
4 Insert the moldable stays in the pockets that are appropriate
for the shape desired. Have the user rest against the back
support.
5 Repeat the process as needed to achieve the desired goals.
Suggestion: The Moldable Stays can be adjusted regularly, as
needed, when conditions or positioning needs change.
Using the BOA Closure System on ACTA-Relief Back
Supports:
1 With the user seated, pull the reel to release tension.
Suggestion: Pop the BOA reels open from the side like a bottle
opener, using an index finger hooked under the reel while the
thumb pushes on the top of the opposite side of the reel.
2 Let the user sink into the back support so the cables form
around them, and then push in the reel to engage the
system.
3 Turn each reel until the desired shape is achieved. The
cables will pull with even tension and conform to the user's
shape.
4 Repeat the process as needed to achieve the desired goals.
Suggestion: Adjust regularly, as needed, when conditions or
positioning needs change.
ACTA-Relief Setup: Ideally, the lowest BOA cable should be located
at the user's pelvis. The second cable from the bottom should
support the lumbar region. The top one or two cables (whichever is
applicable) can then be adjusted to the user's needs and comfort.
Compass Power Mount Hardware Operation Manual
Examples of how Moldable
Stays can be shaped.
11
Adjusting wings on ACTA-EMBRACE back supports:
Please contact Customer Support for additional wings, if needed.
Front view ACTA-
EMBRACE shell
Note: The user will need to transfer out of the wheelchair
before this adjustment is made.
1 When using Compass Power Mount Hardware, wings
are attached to the anterior side of the shell. To
access the wing fasteners, remove the cover from the
back support.
2 Loosen the fasteners to make height and medial-
lateral adjustments or to rotate the wings.
Note: Lateral trunk supports are attached to the wings
and provide additional adjustments.
3 Additional slots are available on most ACTA-EMBRACE
shells for greater range of adjustment or for offset
positioning. As needed, remove the fasteners and
move the wings to the desired slot.
Suggestion: Use wings in the flipped orientation by removing
the fasteners and moving them to the opposite sides of the
shell. Additional wings may be added to achieve a 3-point
lateral support. Mix and match wing sizes as desired.
1
PULL to release.
Use the BOA Closure
System to open up
the chest cavity, raise
the user's line of
sight, and increase
comfort and stability.
Flipped wing
orientation
3
2
PUSH to engage.
TURN to tighten.
Create even pressure
along the entire back
by accommodating
deformities and
allowing for
immersion through the
back support shell.
Increase tension
in areas that need
additional support
and to encourage
proper positioning.