Assembly - Acta-Relief Shell Bracket And Track - Permobil Compass Power Mount Hardware Operación Manual

Assembly - ACTA-Relief Shell Bracket and Track Spacer
For ACTA-Relief and ACTA-Relief LTS. Track spacers for Compass Power Mount Hardware are to be used on ACTA-
Relief only when using a head support and when additional clearance is needed. Refer to the instructions provided
with the head support for installation of the head support and hardware.
Attaching the female tracks to the shell bracket:
1 Line up the holes on the shell bracket (A) with the female
track (B). Make sure that the release levers (C) point out and
away from each other.
2 Fasten securely, using the screws (D). Make sure that the
screws are evenly tightened for correct alignment.
WARNING: After installation is complete, check for
alignment with the mounting bracket. See "Cleaning and
Alignment - Tracks" in this manual.
*Adding track spacers to the shell bracket:
1 Line up the holes on the shell bracket (A) with the
track spacer (E) and the female track (B). Make sure
that the release levers (C) point out and away from
each other.
2 Fasten securely, using the alternate flat head screws
(F) provided. Make sure that the screws are evenly
tightened for correct alignment.
WARNING: After installation is complete, check for
alignment with the mounting bracket. See "Cleaning and
Alignment - Tracks" in this manual.
ACTA-Relief with BodiLink Head Support
If using a head support, track spacers*
may be required for clearance.
All parts, fasteners, and tools required to
adjust spacing are provided.
Compass Power Mount Hardware Operation Manual
Possible spacer
configurations:
Track spacers use .356" (9 mm)
of seat depth
SDU = Total Seat Depth Used
13
A
1
A
1
2.356 in. (6.0 cm) SDU 2.356 in. (6.0 cm) SDU
1 in. Spacer 2 in. Spacer
+ Track Spacer + Track Spacer
Note: The tracks MUST be
attached to the side of the shell
bracket that has the head support
relief cut-out.
B
D
1
1
C
Note: The tracks MUST be
attached to the side of the shell
bracket that has the head support
relief cut-out.
E
B
F
1
C
2.356 in. (6.0 cm) SDU
1 and 2 in. Spacers
+ Track Spacer
2
1
2