Assembly - Acta-Relief Shell Spacers - Permobil Compass Power Mount Hardware Operación Manual

Assembly - ACTA-Relief Shell Spacers

For ACTA-Relief and For ACTA-Relief LTS. Compass Power Mount Hardware requires a certain cover style for the
back support. If converting a back support from manual wheelchair hardware to Compass Power Mount Hardware,
contact Customer Support for the correct cover.
SDU = Seat Depth Used
1 in. Spacer
2 in. (5.1 cm) SDU
Standard ACTA-Relief configuration
Attaching the shell bracket and spacers to the
back support:
1 Remove the cover from the back support
and locate the four holes on the shell (D)
for attaching the power mount hardware. If
already assembled, unscrew the four bolts (A)
to use as alternate spacers.
2 Line up the bolt (A), the safety washer (B), the
flat washer (C), the back support shell (D), and
the spacer (E) with the shell bracket (F).
Note: The bolt (A) and the spacer (E) will vary,
depending on the desired configuration. Use the
longer bolts with deeper spacers.
3 Lightly fasten and continue with the other
three holes using the hex key. After all points
are attached, tighten securely.
4 Replace the cover on the back support.
E
A
40 mm button head bolt (A) 65 mm socket head bolt (A)
1 inch shell spacer (E)
Compass Power Mount Hardware Operation Manual
2 in. Spacer
3 in. (7.6 cm) SDU
3
ACTA-Relief shell without the cover shown
E
A
A
90 mm socket head bolt (A)
2 inch shell spacer (E) 1 and 2 inch shell spacers (E)
A
2
1
E
12
1 + 2 in. Spacers
4 in. (10.2 cm) SDU
B
C
D
Note: The face of the
contoured shell spacer (E) will
match the rounded corners of
the shell bracket (F).
E
F
Note:
The head
support
relief cut-out
MUST face
away from
the back
support.