3. SWITCH THE STIMULATOR ON
Press the ON/OFF button
minating the stimulation at all times, even when the key lock is acti-
vated.
AUTO
Always switch the stimulation off before removing electrodes from
P
the skin.
4. SELECT A PROGRAM (P1–P12)
Select a program recommended by your health care provider by
pressing the PROGRAM button
number is shown on the display.
Note! When selecting a program the amplitude must be set to 00.0
mA for both channels.
5. START THE STIMULATION
Press the INCREASE button
comfortable level of stimulation. Press and hold the button to
increase the amplitude continuously.
Note! Always increase the amplitude cautiously!
Programs P1–P6: These programs have intermittent stimulation, i.e. stimulation alternates with rest
time. The upper part of the stimulation/rest symbol is flashing during stimulation and the bottom part
during rest time. Set the amplitude during stimulation.
The treatment time is preset, but can be changed by using the timer function, see section TIMER.
6. STOP THE STIMULATION
You can stop the stimulation before the program time has elapsed by pressing the DECREASE button
until the amplitudes are 00.0 mA or press the ON/OFF button
An automatically activated key lock prevents unintentional changes during treatment. The key lock is
activated if no button is pressed for 10 seconds. Press any of the DECREASE button
AUTO
AUTO
the key lock.
S
P
When the program is finished, Remaining time "00:00" is flashing on the display.
7. AFTER USE
Turn the stimulation off. Remove the probe(s)/electrodes. Clean the probe(s) according to the instruc-
tions included with your probes.
The last used program is saved when the stimulator is turned off and then pre-selected the next time
the stimulator is turned on.
The stimulator turns off after five minutes of inactivity to spare batteries.
. This button can be used for ter-
AUTO
S
AUTO
AUTO
repeatedly until the program
S
P
for each channel until you reach a
AUTO
AUTO
S
P
.
to deactivate
AUTO
AUTO
S
P
AUTO
P
13
AUTO
S