Installation Overview - MIRKA Motor Drive Cabinet Instrucciones De Manejo

en (original)

Installation overview

General
• Connect the 48 VDC power supply to the motor drive (J2 connector).
• Connect the tool to the motor drive (J3 connector).
Modbus RTU interface
• Use the J1 connector to connect the motor drive to the Modbus RTU bus.
Profinet I/O gateway to Modbus RTU interface
• Connect the 24 VDC power supply to the gateway and connect the DSUB-9 adapter cable between the gateway (X2
connector) and the motor drive (J1 connector).
Digital control interface
• Use the J6 connector to connect the common GND between the systems.
• Use the J5 connector to select the operation using the four digital input signals.
Relay interface
• The N/O relay pins are available on the J4 connector.
Component spare part codes
Name
Power supply 48 V
Power supply 24 V
Hilscher NT 50-RS-EN
Hilscher NT 50-RS-EN adapter cable
Motor drive
Shielded cable for tool (10 m)
Technical data for motor drive
Input
Nominal input voltage
Input voltage range
Mirka code
MIA6513211
MIA6513411
MIA6513311
MIA6514011
MIA6513112
MIA6512311
48 VDC
46 - 50 VDC
Mirka® Motor Drive Cabinet
19