Safety Instructions - MIRKA Motor Drive Cabinet Instrucciones De Manejo

en (original)
Input
Maximum input current
Rated power
Speed control
Speed range
Protection
Overload protection
Overheat protection
Interfaces
Input interfaces
Output interfaces
Environmental
Ambient temperature
Humidity
Storage temperature
Dimensions
Motor drive cabinet
Motor drive
Motor drive mounted in DIN -rail holder

Safety instructions

Electrical installation must be carried out by a competent electrician!
The motor drive has been designed for fixed installations only.
Do not perform any voltage withstand tests on any part of the motor drive or the tool. Product safety has been
fully tested at the factory.
Ground yourself with an anti-static wristband before touching the motor drive (setting jumpers and similar
actions) to avoid electrostatic voltage discharge damage to the motor drive.
Warnings
Make sure that all the AC-DC power supplies are properly earthed and that the motor drive cannot come in
contact with live mains voltage.
20
Mirka® Motor Drive Cabinet
10 A
350 W
4000 - 10000 rpm
Yes
Yes
Modbus RTU (RS-485)
Profinet I/O (gateway module)
4-bit digital inputs (15-33 VDC)
Single pole, non-latching N/O relay, 250 VAC/ 125 VDC, 10 A
0 - 40 °C
Maximum 95% RH, non-corrosive, no dripping water
-20 to 80 °C
380 x 300 x 210 mm (W x H x D)
72 x 30 x 200 mm (W x H x D)
95 x 55 x 210 mm (W x H x D)