MIRKA Motor Drive Cabinet Instrucciones De Manejo página 22

en (original)
Connector
J3
J3
J3
J3
J3
J3
J3
Connector
J4
J4
Connector
J5
J5
J5
J5
Connector
J6
J6
Button description
Button
S1
S2
Indicator description
Indicator
D2
D3
D4
D14
D17
D18
D19
D20
D21
D22
D23
D24
D25
D26
D29
D30
22
Mirka® Motor Drive Cabinet
PIN
P-
NTC+
Phase A
Phase B
Phase C
GND
NTC-
PIN
COM
NO
PIN
DI1
DI2
DI3
DI4
PIN
15V
GND
Description
Self-test button
Reset button
Description
Speed set-point indicator, lit if ≥ 4,000 rpm. Modbus RTU slave address indicator, bit 1.
Speed set-point indicator, lit if ≥ 5,000 rpm. Modbus RTU slave address indicator, bit 2.
Tool status indicator. Lit red when the tool is stopped, lit green when the tool is running.
Motor drive state indicator. Lit green when motor drive is in ON-state. Blinking green when
motor drive is in OFF-state.
Speed set-point indicator, lit if ≥ 6,000 rpm. Modbus RTU slave address indicator, bit 3.
Speed set-point indicator, lit if ≥ 7,000 rpm. Modbus RTU slave address indicator, bit 4.
Speed set-point indicator, lit if ≥ 8,000 rpm. Modbus RTU slave address indicator, bit 5.
Speed set-point indicator, lit if ≥ 9,000 rpm. Modbus RTU slave address indicator, bit 6.
Speed set-point indicator, lit if ≥ 10,000 rpm. Modbus RTU slave address indicator, bit 7.
Modbus RTU slave address indicator, bit 8.
Lit if D2–D3, D17–D22 indicator mode is Modbus RTU slave address.
Lit if digital speed control interface is enabled.
Lit if the alarm status flag is set.
Relay status indicator.
Modbus RTU receive indicator.
Modbus RTU transmit indicator.
Description
P-
NTC+
Phase A
Phase B
Phase C-
GND
NTC-
Description
Relay COM
Relay NO
Description
Digital spped control input bit 1
Digital spped control input bit 2
Digital spped control input bit 3
Digital spped control input bit 4
Description
15 VDC output
GND