Correction Of Malfunctions - WAGNER FINISH CONTROL 3500 Manual De Instrucciones

FinishControl 3500
Warning
If the supply ord of this applian e is damaged, it must only
be repla ed by a repair shop appointed by the manufa turer,
be ause spe ial purpose tools are required.
The wires in this mains lead are oloured in a ordan e with
the following ode:
green/yellow = earth
blue = neutral
As the olours of the wires in the mains lead of this applian e
may not orrespond with the oloured markings identifiying
the terminals in your plug, pro eed as follows:
•
The wire whi h is oloured green and yellow must be
onne ted to the terminal in the plug whi h is marked with
the letter E or by the earth symbol or oloured green or
green and yellow.
•
The wire whi h is oloured blue must be onne ted to
the terminal whi h is marked with the letter N or oloured
bla k.
•
The wire whi h is oloured brown must be onne ted to
the terminal whi h is marked with the letter L or oloured
brown.
•
Should the moulded plug have to be repla ed, never re-use
the defe tive plug or attempt to plug it into a different 13 A
so ket. This ould result in an ele tri sho k.
14

CORRECTION OF MALFUNCTIONS

MALFUNCTION
The unit will not start
No oating material emerges
from the nozzle
Coating material drips from the
nozzle
brown = live
CAUSE
•
No mains voltage
•
Nozzle logged
•
Material volume setting too low
•
Paint ontainer seal damaged
•
No pressure build-up in ontainer
•
Container empty
•
Ventilation hose loose/damaged
•
Feed tube loose
•
Feed tube / feed tube filter logged
•
Air vent on feed tube blo ked
•
Diaphragm stu k
•
The diaphragm is positioned the
wrong way round.
•
Air ap, nozzle or needle soiled
•
Spray atta hment in orre tly
assembled
•
Nozzle loose
•
Nozzle seal is missing or worn
•
Nozzle worn
•
Needle worn
•
Should it be ne essary to ex hange the fuse in the plug only
use fuses approved by ASTA in a ordan e with BS 1362.
Only 13 Amp fuses may be used.
•
To ensure that the fuse and fuse arrier are orre tly
mounted please observe the provided markings or olour
oding in the plug.
•
After hanging the fuse, always make sure that the fuse
arrier is orre tly inserted. With out the fuse arrier, it is not
permissible to use the plug.
•
The orre t fuses and fuse arriers are available from your
lo al ele tri al supplies sto kist.
REMEDY
•
Che k
•
Clean
•
In rease volume
•
Repla e
•
Tighten ontainer
•
Refill
•
Insert or repla e
•
Insert
•
Clean or use another filter
•
Clean
•
Remove and lean (see se tion 13.2)
•
Position the diaphragm orre tly (see se tion
13.2)
•
Clean
•
Assemble orre tly (see se tion 12.1)
•
Tighten Union nut
•
Insert an inta t nozzle seal
•
Change
•
Use new spray atta hment
CORRECTION OF MALFUNCTIONS
GB
23