FREEZER DRAWER
Not all features are on all models.
Ice Bucket
(on some
models)
LED lights
are located
on both
sides of the
freezer
28
How to Remove and Replace Drawer Divider
To remove:
1. Pull the drawer out to the stop position.
2. Slide pan divider to right to release it from pan.
To replace:
Reverse steps 1 and 2 to replace drawer divider.
Top Basket
Divider
Top Basket
Bottom
Basket
Appearance and
features may vary
Top Basket Removal
To remove the top full-width basket on freezer drawer models:
1. Pull the basket out to the stop location.
2. Lift basket up to release it from the slides.
When replacing the basket, make sure that the basket remains mounted on
the side rails and over the slides of the bottom basket.
NOTE: Always be sure to fully close this basket.
Bottom Basket Removal
To remove the bottom full-width basket on freezer drawer models:
1. Open the bottom freezer drawer until it stops.
2. Remove the top freezer basket.
3. The bottom freezer basket rests on the inside tabs on the drawer slides.
4. Lift the front of the basket and pull forward.
5. Release the pin from the slot to remove the basket.
When replacing the bottom full-width basket, tilt the basket back and lower
it into the drawer. Rotate the basket to a horizontal position and press down.
Make sure to place the pin back into the slot.
NOTE: Always be sure that the basket is seated on the bracket tabs before
sliding the drawer back into the freezer.
FREEZER BASKETS
1. An ice bucket in the top basket (on some models).
2. A top full-width basket.
3. A bottom full-width basket (with divider - in some
models).
NOTE: Do not fill baskets higher than the rim of the
basket. This may cause baskets to stick or jam when
opening or closing.