Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
Bank 3
Feature
1 Chirp/Flash
2 Chirp/Flash
1 RF Start Chirp
Off
On
2 Run Time
5 Min.
10 Min.
3 Park Lights
On Steady
Flash
4 Input Check
Voltage
Tach
5 Voltage Level
> 0.5V B4 Start < 0.5V B4 Start
6 Ign. 2 Select
Off With Crank
On With Crank
7 Diagnostics
Off
On
8 Crank Time
0.8Sec
1.0 Sec
9 Gas/Diesel
Gas
Diesel 10
10 Crank Averaging
Averaging
Preset Time
11 RS Shock
Shunt Til Clear
Shunt RS Cycle Shunt From Tx
12 Turbo Select
Off
3 Mins
13 Green/Black
Single Pulse
As D/L Pulse
Aux O/P
14 DBI Select
ADS
Trilogix
15 Time Start
2 Hours
4 Hours
Note: Feature # 10 when set on average, the module will continuously learn start time of the
vehicle when the ignition key is used, and adjust iit's start time accordingly.
Programming Tach Rate:
NOTE: All applications require that tach be programmed.
The unit will not operate unless tach is programmed. If an attempt is made to start the vehicle
via the remote start without first programming tach, the unit will flash the parking lights 7 times
indicating tach has not been learned and stored. If the tach rate is not properly programmed to
the specific vehicle, the unit may not realize that the vehicle is running in certain instances
reengage the starter motor.
The Remote Start Unit will learn the tach rate of most vehicle's single coil, multiple coil packs,
or single injector. To learn tach:
1. Turn the ignition key to the On position.
2. Press and release the valet/program push button switch 3 times.
3. Immediately turn the ignition key Off.
4. Press and hold the valet/program push button switch, then start the vehicle using the
key.
5. When the unit senses the tach signal, the parking lights will begin to flash.
6. Release the valet/program push-button switch. The parking lights will turn on for three
seconds to indicate that the learned tach signal is stored and the unit is out of the tach
learn mode.
NOTE: If the unit fails to learn tach rate due to an improper tachometer connection or a poor tach
source, the parking lights will not flash. To correct this situation, locate and connect the
Purple/White wire to the proper tach signal, and then repeat the tach learn routine.
Diagnostics:
Enter Bank 3 and turn on selectable feature # 7 as described in the feature selection and
setting section.
NOTE: Diagnostic mode is a temporary mode. Once you have accessed the diagnostic mode,
the unit will pause for two seconds then begin to flash the last stored shut down code. This
code will be displayed three times in succession, then the unit will automatically exit the
diagnostic mode.
3 Chirp/Flash 4 Chirp/Flash 5 Chirp/Flash 6 Chirps/Flash
15Min.
20 Min.
DBI Tach
Same As Accy
1.5 Sec
2.0 Sec
Diesel 15
Diesel 20
5 Mins
10 Mins
12
Default
On
10 Min
Steady
Tach
> 0.5
On With Crank
Off
1.0
Gas
Averaging
Shunt Til Clear
Off
Single
ADS
4 Hours
128-9104
12 of 32
Publicidad
