Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
The parking lights will flash a number of times indicating the reason for the last remote start
shutdown. The light flash indications are as follows:
1 Flash
Run timer expired
2 Flashes
Low or no tach signal (RPM)
3 Flashes
Positive inhibit wire activation
5 Flashes
RF shutdown signal received, or manual start trigger wire reactivated.
6 Flashes
High tach signal (RPM)
7 Flashes
Tach signal has not been learned
8 Flashes
Negative inhibit wire activation
TIMED START OPERATION:
To begin the start timer, within 10 seconds of turning off the ignition switch, activate the RF
command to start 2 times. (Press the start button four times). The lights will flash and the siren
will chirp 2 or 4 times. Indicating timed interval mode has been initiated. The vehicle will
automatically start every 2 or 4 hours as programmed. To cancel the timed start mode start the
vehicle either by RF or by the ignition key.
4 PIN DATA BUS PORT (DBI Port)
The 4 pin port located on the side of this module is for proprietary Audiovox data bus interface
modules. These modules are used to access a variety of features in the vehicle which can be
as simple as door trigger inputs, to more complex door lock outputs, or transponder interfaces
for remote starting. DO NOT connect anything to this port other than the Audiovox DBI interface
modules or damage to the Remote Start will occur. All installation instructions for the DBI
modules will be packaged with the individual component along with the proper 4 pin wiring
harness requires to access the data transmit & receive as well as the proper voltage levels for
the interface.
COMPLETING THE INSTALLATION:
Adjusting the Shock Sensor: If used, the sensitivity of the pre - detect setting is automatically
set 30% less sensitive than the full trigger setting.
Using a small screwdriver, gently turn the adjustment screw fully counterclockwise, then clock-
wise 1/4 turn. (DO NOT over turn this screw. Maximum rotation for this adjustment is 270°).
Close the hood, trunk and doors then arm the alarm.Wait 6 seconds for the accessories trigger
zone to stabilize, then firmly strike the rear bumper with the side of a closed fist considering the
amount of force required to break a window.
CAUTION: Never perform this test on the vehicle's glass, as you may break the window.
Turn the adjustment screw clockwise (increasing sensitivity) about ¼ turn and re-test.
Repeat this procedure until the alarm sounds. Ultimately, one medium strike to the rear
bumper will cause the alarm to emit pre-detect warning tones, one hard strike will cause the
alarm to trigger.
WARNING ! Setting the sensitivity too high can cause false alarms due to noise vibrations from
passing trucks and heavy equipment. To decrease sensitivity, turn the adjustment screw counter
clockwise.
NOTE: This unit has the ability to learn the dome light delay time, up to 60 seconds. If the
vehicle has delay interior lights, and you wish to avoid three chirp, defect zone, indication
normally associated with this type of interior light, we suggest you learn the interior light
delay.
13
128-9104
13 of 32
Publicidad
