Charging The Batteries - Datalogic GRYPHON BT Serie Guía Rápida

GRYPHON™ BT

CHARGING THE BATTERIES

By placing the reader onto the C-GRYPHON battery charger it is possible to
charge the Gryphon™ BT batteries. Make sure the charging LED goes on.
The LEDs positioned on the cradle signal the charge status, as described in the
following table:
LED
Power on /
Data
Charging
Charge
completed
Charging +
Charge
completed
Power on / Data
(yellow LED)
After many recharging cycles NiMh and NiCd batteries may tend to lose their
operating autonomy. This condition can be overcome by positioning the
Gryphon™ BT onto the C- GRYPHON charger and pressing the "battery
reconditioning" button. A complete discharge cycle may last up to 2 hours.
Yellow On = C-GRYPHON is powered.
Yellow Blinking = C-GRYPHON receives commands
from the Host.
Red On = the battery charge is in progress.
Red Blinking = the battery reconditioning is in progress.
Green On = the battery is completely charged.
Red and Green Blinking together = the reader is not
correctly placed onto the charger.
Battery reconditioning
button
STATUS
Charging
(red LED)
Charge completed
(green LED)
UK/US
3