Gryphon™ Bt As Master; Sleep State - Datalogic GRYPHON BT Serie Guía Rápida

UK/US
If the PIN of the Bluetooth
the PIN "1234". The Gryphon™ BT Slave will emit four ascending
tones indicating radio connection.
NOTE
After the Gryphon™ BT reader indicates radio connection (see the table at
page 7), you can start sending barcodes.
If the Master remote Bluetooth
communication can be established with up to 7 Slave readers at the same time.
Gryphon™ BT as Master
A Gryphon™ BT is Master when the remote Bluetooth
with a Bluetooth
must be configured with the address of the Slave device to which it wants to
communicate.
By default, at startup the reader initializes the communication with the Slave. If
the connection is successful, the reader can send barcodes to the Slave
device.
If the connection is not successful, you can attempt a connection manually by
double-clicking the reader trigger. Radio connections can also be managed
manually as described in the Gryphon™ BT Reference Manual on the
configuration CD-ROM.
During the request of radio connection or disconnection with a remote
®
Bluetooth Slave device, the reader emits a series of ticks and short blinks of
the blue LED.

SLEEP STATE

The µP in the reader enters a "Sleep" state after 5 minutes of no reading for
minimum power consumption.
6
®
barcode printer. Once set as Master, a Gryphon™ BT reader
®
Master device cannot be disabled, use
®
device can support a piconet, the
DATALOGIC
®
device is Slave, i.e.