Etherma SOLAMAGIC S1 Instrucciones De Montaje Y De Uso página 129

2b. Installation, radiant heater S3 and D3
with T-brackets
Heater type Power
IR 05008 2500 W
DS 05002 2000 W
DS 05006 2000 W
Note:
The radiant heater has a one-sided swivel range in the direction of
the oblong hole side, depending on the mounting orientation of the
T-bracket.
When mounting on a wall, the T-bracket must be mounted with the
oblong hole side at the bottom (picture below), when mounting on the
ceiling with the oblong hole side in front.
Step 1: Installing the T-brackts
• Install the S3 or D3 radiant heater using 2 T brackets at a separation of 400 mm
while observing the safety distances and safety instructions (see Appendix 2).
• To make assembly easier, remove the adapter claw (6) from the T-bracket (1)
by loosening the screws (11) (illustration below).
• Mount the T-bracket (1) with the silicone plate (2) underneath on the mounting
surface with 2 screws each as shown in the following figure.
15
Step 2: Installing adapter claws on the T-brackets
• Fit adapter claws (6) at both of the T-brackets installed on the mounting sur-
face, fit safety washer (12) between the T-bracket and adapter claw and screw
in hex socket head screws (11) from outside into the T-bracket (Illustration
above). In the case of ceiling mounting, the adapter claw must be rotated 180°
and screwed onto the holder, in contrast to the illustration.
Wall installation
Horizontal



12 6
2 1
129
Ceiling installation
Vertical Horizontal



11
A
Inclined