Initial Operation; Cleaning Instructions - Etherma SOLAMAGIC S1 Instrucciones De Montaje Y De Uso

Initial operation

1. Where fitted, completely remove the transport protection on the reflector.
2. Connect the enclosed power lead (A) to the heater (B) and secure using the
retaining clip (C).
3. Make the connection to the power supply (Schuko/mains plug)
C
B
For those models without a switch, heating starts immediately upon plugging of
the plug into the socket. For models with a switch or radio receiver, heating starts
upon switching of the switch or via remote control.

Cleaning instructions

• Disconnect the device from the mains.
• Allow the casing to cool.
• Wipe the casing clean with a moist, soft cloth. Do not use any detergent.
Never immerse the device in liquids nor spray-wash it.
Possible discolouration of the protective grille due to heat effects results
from normal physical processes and is not a defect.
A
137