Etherma SOLAMAGIC S1 Instrucciones De Montaje Y De Uso página 130

Step 3: Installing the heater on the T-brackets
• Push the securing lugs (3) with the ring (4) from the cable side into the dovetail
groove for approx. 530 mm and 130 mm.
• Tighten the 3.5 x 6.5 screws (5).
• Align the eccentric tensioner (7) of the adapter claw (6) in the vertical direction
(C), see figure below.
• Attach heater (B) at the top in the hammer groove side on the adapter claws
(6) and swing in at the bottom on the eccentric tensioner side (7).
Warning: The adapter claws must now engage in each of the two device
grooves (visual check)
The securing lugs (3) must now be located directly alongside the adapter claws
(6).
• Tighten the eccentric tensioners (7) by turning the supplied 5 mm hex-key in
a clockwise direction (approx. 80° angle of turn). The heater must be tightly
connected to the adapter claws so that it is free from play.
Attention: there is no rotation-stop; do not turn through 180° – do not
over-turn the eccentric spanner!
• Fit each retaining ring (4) in the cut-out (A) of the adapter claw (6).
• To set or adjust the heat radiating direction, use a 5 mm hex-key to undo the
screw (11, left adapter claw side according to the figure below), move the hea-
ter to the required radiating direction and re-tighten the screw (11).
5
3
6 1 B
11
530
7 3,4,5
130
7
C
A
4
3