Anest Iwata SUPERnova LS-400 Manual De Instrucciones página 5

always ensure the best spray gun performance.
-Make sure that the PH level of cleaner does not exceed the limit.
PH level:6.0~8.0(but only during cleaning)
DISASSEMBLY PROCEDURE
-Before disassembly, fully clean fluid passages.
a
d. Fluid needle packing set(3)
Must always be adjusted while fluid needle set(2-2) is inserted and in the following way:
Tighten it by hand (about a 60 degree turn) and then with spanner. When you remove needle packing set(3), do not leave plastic piece of needle
packing set(3) in the gun body.
d
e. Air valve assembly(8)
Assemble air valve(8), air valve spring(9) and adj. guide set(10) together. Next, insert fluid needle set(2-2) into fluid adj. guide set(10), fit it to gun
body set(4) and screw fluid adj. guide set(10).
-If you try to fit air valve spring(9) and air valve(8) to gun body set (4) without fluid needle set (2-2), air valve (8) will not be fitted correctly and the
packing in the fluid adj. guide set (10) will be damaged.
f. Disassembly of pattern adjustment set (5) and/or air adjustment set (15).
B
A
a. Disassembly fluid nozzle (2-1)
While keeping fluid needle (2-2) pulled(triggering) in order to protect its seat section.
b.
Disassemble fluid needle set (2-2). (only when strictly necessary)
c.
Remove fluid adj. knob(13), fluid adj.set (12) and needle spring(11), extracting the spring and
fluid needle set (2-2), from the back of fluid adj. guide set (10) still assembled on the gun
body (4).
c
-If you tighten fluid needle packing set (3) too much, fluid needle set(2-2) will not move smoothly,
resulting in paint leakage from tip of fluid nozzle(2-1).
-Try to adjust it carefully while pulling trigger and confirming movement of fluid needle set (2-2).
-If you tighten it too much, repeat operation.
e
In order to disassemble pattern adj. set (5) and/or air adj. set (15), first of all remove,
FIG.1
adjustment knob (6) carefully as illustrated in Fig.1.
Then manually turn the hexagon knob (A) of the adjustment counterclockwise to open it
completely and unscrew the hexagon face (B) with a spanner turning it counterclockwise.
-To reassemble pattern adjustment set (5) and/or air adjustment set (15), reverse the
procedure.
Important
FIG.2
Before reassembling pattern adjustment set and/or air adjustment set, make sure that
these operations are carried out with the adjustment fully open.(Fig1)
,