Vermeiren Albatros Manual De Instrucciones página 15

4.2.3 Dismantling
WARNING: Risk of clamping - Take care that no body parts and wires get trapped,
L
crushed or cut during dismantling.
WARNING: Risk of injury - Check the emergency stop (red pushbutton on the control
L
box) is activated, to avoid unintentional adjustment movements.
2
1
7. Attach the footplate with the hooks to the chassis of the
patient hoist.
8. Attach the leg support by the locking pin. Position the leg
support to the desired height and depth.
1. Secure the two casters at the back of the chassis by pressing
the caster brake plates down gently to their end stops with the tip
of your foot. To release the brake, push the brake plate gently back
up again with the front of your foot until the casters are free.
2. Remove the leg support by the locking pin.
13
Installation and adjustment
5. Remove the actuator gently by
pulling out of the black clip (1).
6. Attach the
cantilever arm by the locking pin (2). Take
care that the actuator is positioned very
well between the cantilever arm.
Albatros
2022-07
actuator on the
EN
NL