Publicidad
Idiomas disponibles
Idiomas disponibles
MWE-150-2DIS.book Seite 39 Mittwoch, 29. Juni 2005 5:20 17
All manuals and user guides at all-guides.com
magic watch
6.3
Laying the sensor extension cables
When laying cables, ensure that:
They are not kinked or twisted
They do not rub on edges
They are not laid in sharp edged ducts without protection (see fig. 3,
page 4).
Note
The extension cables are marked: L (left) and R (right).
This marking helps you connect them to the control electronics to
ensure that the display is correct.
Caution!
Before making any drill holes, ensure that no electrical cables or
other parts of the vehicle can be damaged by drilling, sawing and
filing.
➤ Take suitable precautions to protect holes made in the bodywork from
water penetration, for example by spraying the cable and the sleeve with
sealant.
➤ Where possible, use existing rubber bungs in the boot for laying the
extension cables.
If there are no rubber bungs, make a suitable hole with a diameter of
around 13 mm and insert a cable sleeve.
Note
Pull the socket connectors of the extension cables through the
cable sleeve before inserting the sleeve in the body work.
➤ Lay out the extension cables in the boot so that they cannot be damaged
under any circumstances (e.g. by flying grit).
➤ Carefully fasten the extension cables behind the bumper.
➤ Insert the sensor plugs into the sockets of the corresponding extension
cables (see fig. 15 A, page 8).
Installing MAGIC WATCH
39
Publicidad
