Waeco MAGIC WATCH MWE-150-2DIS Instructions De Montage Et De Service página 42

MWE-150-2DIS.book Seite 42 Mittwoch, 29. Juni 2005 5:20 17
All manuals and user guides at all-guides.com
Installing MAGIC WATCH
6.6 Installing the speaker on the boot cover
The piezoelectronic speaker should be glued to or mounted on a suitable
place on the boot cover.
Note the following information when selecting the installation location for the
piezoelectronic speaker:
Note the length of the speaker cable.Note that the boot cover swings
upwards on vehicles that have a big tailgate.
The piezoelectronic speaker must not be covered or damaged by any
objects placed on the boot cover.
You can set the volume to either off (Off), low (Lo), or loud (Hi), using the
switch on the front of the speaker.
➤ Insert the socket of the piezoelectronic speaker into the plug of the exten-
sion cable (see fig. 17 A, page 8).
➤ Guide the extension cable to the control electronics and insert the socket
of the extension cable into the connection on the control electronics (see
fig. 17 B, page 8).
➤ Remove the protective foil and affix the speaker ...
➤ Or attach it using suitable screws.
6.7 Connecting the control electronics
Caution!
Make sure the polarity is correct.
On some vehicles, the reversing light only works when the ignition
is switched on. In this case, you must switch on the ignition in
order to identify the positive and negative wires.
➤ Connect the red cable (fig. 18.2, page 8) on the control electronics to the
positive wire (+) of the reversing light (fig. 18.1, page 8).
➤ Connect the black cable (fig. 18.3, page 8) to the earth wire (–) of the
reversing light or to earth (bodywork).
42
magic watch