(translated from italian)
14
EVERY DAY USE
FOREWORD
SAFETY
WARNINGS
AUTHORIZED
FOR USE
PERSONNEL
ATTENTION
ATTENZIONE
15
MAINTENANCE
Safety
instructions
Authorized
maintenance
personnel
DANGER OF
FROST
ATTENTION
16
NOISE LEVEL
Under normal operating conditions, noise emission of all models does not exceed 70 dB(A) at a distance
of 1 metre from the electric pump.
This manual is the property of PIUSI S.p.A. Any reproduction, even partial, is forbidden.
MAKE SURE THAT THE TANK LEVEL NEVER GOES DOWN UNDER THE
SUCTION OF THE PUMP. THE PUMP CANNOT RUN DRY
During use it is mandatory to use personal protective equipment (PPE)
However, keep the following minimum recommendations for proper pump
operation into account
Use of the SQUALO pump is reserved exclusively for specialized personnel.
Any tampering can lead to the decay of performance and danger for people
and / or things, in addition to the forfeiture of the warranty.
To avoid damaging the pump, after use, make sure the pump is off.
In case of a power break, switch the pump off straight away.
Should any sealants be used on the delivery circuit of the pump, make sure
that these products are not released inside the pump.
Foreign bodies in the delivery circuit of the pump could cause malfunction-
ing and breakage of the pump components.
In case of pump automatic shut off through the timer, switch off and switch
on the pump through the main switch
The SQUALO pump has been designed and built to require minimal main-
tenance.
Before carrying out any type of maintenance and before being taken out of
the containment tank, the pump must be disconnected from all sources of
electrical and hydraulic power supply,
During the maintenance it is mandatory to use personal protective equip-
ment (PPE)
All maintenance must be performed by qualified personnel. Tampering can
lead to performance degradation, danger to persons and/or property and
may result in the warranty being voided.
When the pump remains inactive for a long time at temperatures of less
than +12°F/-11°C, the pump body must be completely emptied, to prevent
possible cracking of the hydraulic components.
During installation and periodically, provide for verification of the ground-
ing circuit in compliance with current regulations.
SUBMERSIBLE PUMP
15
15 /52
/124