Last Function Memory; Initialization Of The Microprocessor - Denon AVR-1602 Instrucciones De Operación

ENGLISH
TP search
Use this function to find RDS stations broadcasting traffic program (TP stations)
1
Set the input function to "TUNER".
2 Press the RDS button until "TP
SEARCH" appears on the display.
3 Press the PRESET UP or DOWN
button TP search begins.
If no TP station is found with above operation, all
the reception bands are searched.
4
The station name is displayed on the display after
searching stops.
5
To continue searching, repeat step 3.
If no other TP station is found when all the
frequencies are searched, "NO PROGRAMME"
is displayed.
RT (Radio Text)
"RT" appears on the display when radio text data is
received.
When the RT button is pressed while receiving an RDS
broadcast station, the text data broadcast from the
station is displayed. To turn the display off, press the
RT button again. If no text data is being broadcast, "NO
TEXT DATA" is displayed.
22
All manuals and user guides at all-guides.com
1 3 2
B
(Main unit)
(Main unit)
(Main unit)
B

16 LAST FUNCTION MEMORY

• This unit is equipped with a last function memory which stores the input and output setting conditions as they
were immediately before the power is switched off.
• The unit is also equipped with a back-up memory. This function provides approximately one week of memory
storage when the main unit's power operation switch is off and with the power cord disconnected.

17 INITIALIZATION OF THE MICROPROCESSOR

When the indication of the display is not normal or when the operation of the unit does not shows the reasonable
result, the initialization of the microprocessor is required by the following procedure.
B
1, 2 2
"RT"
1
Switch off the unit using the main unit's power
operation switch.
2
Hold the following SPEAKER A button and B
button, and turn the main unit's power operation
switch on.
3
Check that the entire display is flashing with an
interval of about 1 second, and release your fingers
from the 2 buttons and the microprocessor will
be initialized.
NOTES:
• If step 3 does not work, start over from step 1.
• If the microprocessor has been reset, all the
button settings are reset to the default values
(the values set upon shipment from the factory).