SPORT-ELEC SPORT New Generation Manual De Utilización página 10

Reminder : Before use check that the SPORT-ELEC SPORT New Generation on/off switch is on '0' and that the 4
channels A and B power control knobs are turned to minimum (turned all the way to the left, on "0").
To adjust, consult the summary table given on page 59.
MUSCLE BUILDING SPEED
P6
Once or twice a week
Stage
Turn the green rest control knob (
1°
Turn the red work control knob (
2°
Turn the yellow frequency control knob (
3°
Set the blue width of pulse button (
4°
Turn the on/off switch to "I"
5°
Progressively turn the power buttons of channels A and B from 0 and 3*.
6°
*variable depending on which muscles you wish to treat
MUSCULATION ENDURANCE
P7
Once or twice a week
Stage
Turn the green rest control knob (
1°
Turn the red work control knob (
2°
Turn the yellow frequency control knob (
3°
Set the blue width of pulse button (
4°
Turn the on/off switch to "I"
5°
Progressively turn the power buttons of channels A and B from 0 and 3*.
6°
Note : You can increase or decrease the rest periods between each contraction (green knobs) and the length of contractions (red
knobs). Should you experience discomfort, turn generators A or B to position "0", change the position of the electrodes causing
the discomfort, and then turn the power back on. If discomfort persists, end the session. Do not exceed 40 minutes of muscle buil-
ding per session and per day.
*variable depending on which muscles you wish to treat
RELAXATION
P8
Stage a) - 10 minutes
1°
Turn the green rest control knob ( ) to 2.
2°
Turn the red work control knob ( ) to 2.
3°
Turn the yellow frequency control knob (
Set the blue width of pulse button ( ) according
4°
to the adjustments* in table p.59
5°
Turn the on/off switch to "I"
6° Progressively turn the power buttons of channels A
and B from 0 and 1,5*.
*variable depending on which muscles you wish to treat
Result : Your muscles are massaged and relaxed gently. This use of SPORT-ELEC SPORT New Generation is ideal follo-
wing a session of muscle building or sporting activity.
15 minutes
) to 1.
) to 1.
) to 1,5.
) according to the adjustments* in table p.59
40 minutes
) to 5.
) to 4.
) to 1,5.
) according to the adjustments* in table p.59
After each effort
Stage b) - 10 minutes
(without turning the appliance off)
1°
Turn the green rest control knob (
2°
Turn the red work control knob (
) to 2.
3° Turn the yellow frequency control knob (
Set the blue width of pulse button (
4°
to the adjustments* in table p.59
5°
Turn the on/off switch to "I"
Progressively turn the power buttons of channels A
6°
and B from 0 and 2*.
*variable depending on which muscles you wish to treat
19
5
At the end of a session turn the 4 power control knobs back to "0" (turned all the way to the left),
and turn the on/off switch to position "0". Disconnect from power source. Disconnect SPORT-ELEC SPORT
New Generation from the electrodes and pack it all in its case. Then gently peel off the electrodes, mois-
ten them with a few drops of water, and replace them carefully on their support. Store the electrodes in a
cool dry place. Keep you SPORT-ELEC SPORT New Generation stored in its case.
ADVICE
- For optimum use, study the diagrams given in this booklet.
- The cycle of programmes may be repeated on a different muscle area, but should not be used for more than 40
minutes on any one muscle area.
- Electrodes have a life of about 60 uses. New electrodes can be ordered directly from the Company headquarters :
SPORT-ELEC S.A., B.P. 35 - 27520 BOURGTHEROULDE - Tél. : 00.33.2.32.96.50.50
or contact your local supplier.
SAFETY CHECKS : The following points must be
checked every two years :
1- Check equipment for any obvious wear
2- Check that the equipment is good working order:
* legibility of writing on the casing
* switch, contacter
Storage and transport conditions
- Ambient temperature between + 10°C and + 40°C
SPORT-ELEC SPORT New Generation technical specifications
- 4 independently adjustable power channels
- Alternating current and voltage (clinically tested current).
- Rest time : 1s to 12 s - green indicator light
- Working time: 2s to 12 s - orange indicator light
- Pulse frequency: 2 Hz to 115 Hz
- Pulse span : 180 µs to 350 µs.
- Maximum output voltage : 97 Vcc in open circuit
- Maximum output voltage : 95 Vcc charged on 500 W
- Switch-on safety : 100% (whatever the position of power potentiometers)
- Automatic cut-off after 40 minutes of continuous use
- 4 x 2 electrodes of 89 x 50 mm
- Separate supply block - 230 V 50 Hz
- Do not use a different power supply to the one supplied with the SPORT-ELEC equipment.
) to 1.
Power supply model included :
) to 5.
- Consumption 6VA
) to 5.
- Size : 148 X 96 X 36.5 mm
) according
-
95 Vcc/500 •
- Classification type BF.
- Caution : read instructions carefully
- Cl II.
3- Check the reliability of various accessories:
* good condition of electrode wire
* good condition of electrodes (no tears or defects)
4- Measure electric values:
* on a 500 ohm load the maximum output voltage
should not exceed 100V.
- Relative humidity between 30% and 75%
- Pressure 700 hPa
0050.120.1S.01.SE
60 601-1
Advice :
- The appliance and electrodes may be disposed of with
household waste, with due consideration for the environment.
20