Publicidad
Idiomas disponibles
Idiomas disponibles
DC-700ETH/T
3. START-UP
The start-up of the DC-700ETH/T microphone desk must be carried out in an orderly manner by following these three basic
steps:
1. Configure the IP addresses of the DC-700ETH/T. Follow the section
2. Add the device to the structure of the public address system (i1) using the Call Point or CallPoint Configurator software.
Follow section
3.2.
3. Configure the appearance of the display and the DC-700ETH/T's own controls. Follow the section
3.1. Configuration of the DC-700ETH/T IP addresses
1. Connect the power supply to the DC-700ETH/T.
2. A few seconds after the software has started, long press and hold on any point in a clear area of the screen and a
circular selection menu will appear.
3. Select Configurations.
4. Enter the administrator password
click OK.
5. Select the
GENERAL
tab.
6. Press
to enter the desired IP addresses (the IP
addresses must be in the same range as the IP
addresses of the public address systems in the
installation) and press OK.
7. Press
CHANGE
and then
device will restart.
3.2. DC-700ETH/T configuration from Call Point or Call Point Configurator software
Add the device to the structure of the public address system (i1) using the Call Point or CallPoint Configurator software. To
do so:
1. Connect the Ethernet network cable to the DC-700ETH/T.
2. From the public address server PC, start the CallPoint or CallPoint Configurator software. If you are using the free
CallPoint Configurator distribution software, skip to step 4.
3. Access the installation screen by opening the
in the menu bar.
Configuration and User Manual. Version 5.2.001
DC-700ETH/T.
(1234
and
by default)
YES
to apply the changes. The
Settings
Configuration and user's manual
3.1.
menu and select Installations, or click on the icon
R+D Department
3. START-UP
3.3.
11
Publicidad
