Publicidad
Idiomas disponibles
Idiomas disponibles
8.2 Error messages
Error code
Error message
Protective cover is opened during the
008
crimping cycle. Crimping cycle not ended.
Open the protective cover.
010
Start sensor outputs incorrect signal.
012
Magazine not correctly installed.
013
Ferrule is in the crimping tool.
Motor position not correct.
014
Crimp cylinder not positioned correctly.
015
Service piece counter has reached
050
200,000 cycles.
Supply voltage too low.
080
Voltage < 18 Volt.
Supply voltage is too high.
081
Voltage > 30 Volt.
Machine overheating.
090
Temperature warning at 50°C.
Machine overheating.
091
Temperature warning at 60°C.
Crimp cycle cannot be ended.
100
Crimp cycle cannot be ended.
101
Crimp cycle cannot be ended.
102
Ferrule is in the crimping tool.
103
2859970000/00/02.2022
Recommended action
► Open the Service/Jog mode menu.
► Jog forward or backward until the wire is released.
► Tap Reference.
► Close the protective cover.
► Contact Weidmüller service.
► Check and correct the fit of the transport unit.
► Remove the ferrule from the crimping tool, for instance us-
ing tweezers.
► Contact Weidmüller service.
► Check and correct the position of the crimp cylinder (turn
and snap into place).
► Contact Weidmüller service.
► Check the supply voltage.
► Contact Weidmüller service.
► Check the supply voltage.
► Contact Weidmüller service.
► Switch off the machine and allow it to cool off.
► If the error occurs repeatedly, contact Weidmüller service.
► Switch off the machine and allow it to cool off.
► If the error occurs repeatedly, contact Weidmüller service.
► Look for any blockages and correct them.
► Open the Service/Jog mode menu.
► Jog forward or backward until the wire is released.
► Tap Reference.
► Look for any blockages and correct them.
► Open the Service/Jog mode menu.
► Jog forward or backward until the wire is released.
► Tap Reference.
► Remove the wire.
► Clean the start sensor.
► Remove the ferrule with tweezers.
Troubleshooting
49
Publicidad
Solución de problemas
