Evolution R185SMS-Li Instrucciones Originales página 19

www.evolutionpowertools.com
CHECKING AND ADJUSTING OF THE PRECISION ANGLES
Note: This machine has been accurately set up and adjusted
at the factory. If it is suspected that some of the precision
angles have been lost (due perhaps to normal workshop
attrition) they can be reset by following the procedure
outlined below.
Note: Several checks/adjustments are possible on this
machine. The operator will require a set square (not supplied)
to carry out these checks and adjustments.
WARNING: Checks/adjustments must only be conducted
with the battery removed from the machine.
BEVEL ANGLES (0˚ & 45˚) 0˚ Bevel Stop Adjustment
Ensure that the cutting head is in the locked down position
with the latching pin fully engaged in its socket.
Ensure that the cutting head is upright, against its stop and
the bevel pointer is indicating 0˚ on the scale. (Fig. 21)
Place the set square on the table with one edge against the
table and the other edge against the blade (avoiding the TCT
tips). (Fig. 22)
If the blade is not at 90 degrees (square) with the rotary
table, then adjustment maybe required.
• Loosen the bevel lock handle and tilt the cutting head to
the left.
• Loosen the locknut on the Bevel Angle adjustment screw.
(Fig.23)
• Use a Hex Key to turn the screw in or out to adjust the
blade angle.
• Return the cutting head to its upright position and recheck
the angular alignment against the set square.
• Repeat the above steps until correct angular alignment is
achieved.
• Tighten the Bevel Angle Adjustment locknut securely.
0˚ Bevel Pointer Adjustment
Note: The operator must be satisfied that the blade is set
exactly perpendicular to the table when in the upright
position and against its stop.
• If the pointer is not in exact alignment with the 0˚ mark on
the angle scale adjustment is necessary.
• Loosen the Bevel Pointer screw using a #2 Phillips
screwdriver. (Fig. 24)
• Adjust the Bevel Pointer so that it is in alignment exactly
with the 0˚ mark.
• Retighten the screw.
Fig. 21
Fig. 22
Fig. 23
Fig. 24
19
EN