APRILIA eSR1 Manual Del Usuario página 25

Brake lever adjustment
eSR2 /eSR2 EVO
If the brake is too tight or too loose, adjust it
by loosening or tightening the screw (A).
If the brake lever is too soft or too hard even
after following the instructions in the first step, it
may be necessary to repeat the operation until
the optimal setting has been reached.
eSRZ
eSR1
A
If the brake is too tight or too loose, use the Allen
wrench to loosen the screw (A), then adjust the
brake cable, (shorten the brake cable at the top
if it is too tight; if it is too loose, pull the brake
cable downwards) and then, retighten the screw
(A).
Check the correct alignment between the brake
caliper and the disc. Use the screws (B) and (C)
to adjust the position / alignment on the disc, if
necessary.
If the brake is too tight or too loose, use the Allen
wrench to loosen the screw (A), then adjust the
brake cable, (shorten the brake cable at the top
if it is too tight; if it is too loose, pull the brake
cable downwards) and then, re-tighten the screw
(A).
Check the correct alignment between the brake
caliper and the disc. Use the screws (B) and (C)
to adjust the position / alignment on the disc, if
necessary.
24
C B A