Insert The Batteries - TFA 30.3057.01 Instrucciones De Uso

TFA_No. 30.3057_Anleit_02_22 09.02.2022
MULTI-SENS – Wireless Thermo-hygrometer
Thank you for choosing this instrument from TFA.
1. Before you use this product
• Please make sure you read the instruction manual carefully.
• Following and respecting the instructions in your manual will prevent damage to your instrument and
loss of your statutory rights arising from defects due to incorrect use.
• We shall not be liable for any damage occurring as a result of non-following of these instructions. Like-
wise, we take no responsibility for any incorrect readings or for any consequences resulting from them.
• Please pay particular attention to the safety notices!
• Please keep this instruction manual safe for future reference.
2. Delivery contents
• Wireless thermo-hygrometer
• 3 thermo-hygro sensors (cat.-no. 30.3221.02)
• Instruction manual
3. Range of application and all the benefits of your new instrument at a glance
• Controls indoor and outdoor climate
• With internal sensor and 3 wireless radio-controlled transmitters (433 MHz) for monitoring temperature
and humidity in up to 4 rooms
• Maximum and minimum values
• Trend indicator
• Comfort level measurement
• Radio-controlled clock with date
4. For your safety
• This product is exclusively intended for the range of application described above. The product should only
be used as described within these instructions.
• Unauthorized repairs, alterations or changes to the product are prohibited.
Caution!
Risk of injury:
• Keep these devices and the batteries out of reach of children.
• Small parts can be swallowed by children (under three years old).
• Batteries contain harmful acids and may be hazardous if swallowed. If a battery is swallowed, this can lead
to serious internal burns and death within two hours. If you suspect a battery could have been swallowed
or otherwise caught in the body, seek medical help immediately.
• Batteries must not be thrown into a fire, short-circuited, taken apart or recharged. Risk of explosion!
• Low batteries should be changed as soon as possible to prevent damage caused by leaking.
• Never use a combination of old and new batteries together, nor batteries of different types.
• Avoid contact with skin, eyes and mucous membranes when handling leaking batteries. In case of contact,
immediately rinse the affected areas with water and consult a doctor.
Important information on product safety!
• Do not expose your device to extreme temperatures, vibrations or shocks.
12
15:56 Uhr Seite 7
MULTI-SENS – Wireless Thermo-hygrometer
• Protect it from moisture.
• The transmitters are protected against splash water, but are not watertight. Should you decide to use the
transmitters in the outdoor area, choose a shady and dry place for the transmitters.
5. Elements
5.1 Base station (Receiver)
A: Display (Fig. 1):
Upper display
A 1: Indoor symbol
A 3: Humidity
A 5: Comfort-level symbol
A 7: Daylight Saving Time symbol
Lower display for transmitters 1-3
A 9: Radio-controlled symbol
A 11: Humidity
B: Buttons (Fig. 1):
B 1: Set button
B 3: MaxMin/+ button
C: Housing (Fig. 1+2):
C 1: Transmitter site labels (blank)
C 3: Stand
5.2 Transmitter (Fig. 3):
D: Buttons:
D 1: Channel search switch
E: Housing:
E 1: LED signal lamp
E 3: Wall mount hole
6. Getting started

6.1 Insert the batteries

• Place the instruments on a desk with a distance of approximately 1.5 meters. Avoid being close to possible
sources of interference such as electronic devices and radio installations.
1. Open the battery compartment of the first transmitter.
2. Set the switch to the channel 1 position.
3. Insert two new AA 1,5 V batteries, polarity as illustrated.
4. Close the battery compartment carefully.
• Repeat steps 1-4 for the other two transmitters. Select different channels for each sensor with the switch.
• Open the battery compartment of the base station and insert two new AA 1.5V batteries, polarity as illu-
strated.
A 2: Temperature
A 4: Trend arrows
A 6: Time with seconds
A 8: DCF symbol, date
A 10: Temperature
B 2: Channel button
B 4: RCC/- button
C 2: Battery compartment
D 2: TX-button
E 2: Battery compartment
13