Handling Of Functions And Programs - Kroeplin F102 Manual De Instrucciones

4. Handling of functions and programs

Function
Zero point adjustment
Start SETUP
OFFSET
Adjustment
Adjust + / -
Select next digit
Adjustment
upwards
Adjustment
downwards
Quitting
Adjustment of the tolerance limits in ABS
Start SETUP
TOL
Adjust lower
tolerance limit
Adjust first digit
Select second digit
Adjust second digit
Select third digit
Adjust third digit
Select fourth digit
Adjust fourth digit
Adjust upper
tolerance limit
Basic Action
2x
Result
SETUP Menu can be started within every
measuring mode
Possible 0 point adjustment according to
resolution in certain ranges (see "9. Tech-
nical Details"). If the absolute OFFSET is
exceeded, the error report ERR 07 is
shown.
unsigned
= plus
signed
= minus
Applies for the blinking digit (scale inter-
val 0,005mm = 3 decimal places)
After adjustment of the last digit
Example: 20,00 +/- 0,05 mm
SETUP Menu can be started within every
measuring mode
Lower tolerance limit
Attention!
TOL LO must be lower than TOL UP
After short display TOL LO, the last
saved value will always be shown
MODE counts upwards
DATA counts downwards
Number of digits depending on the scale
interval
After short display TOL UP, the last saved
value will always be shown
20
Remarks