Service And Maintenance; Engine Oil - Stiga VILLA ROYAL Instrucciones De Uso

All manuals and user guides at all-guides.com
GB
Never drive with the cutting deck in the
raised position. This damages the deck
drive belt.

SERVICE AND MAINTENANCE

SERVICE PROGRAM
In order to keep the machine in good condition, as
regards reliability and operational safety as well as
from an environmental perspective, STIGA's serv-
ice program should be followed.
The contents of this program can be found in the
attached service log.
We recommend that an authorised workshop car-
ries out every service. This guarantees that the
work is performed by trained personnel and with
genuine spare parts.
At every service, the service log should be
stamped. A "fully stamped" service log is a valua-
ble document that improves the machine's second-
hand value.
PREPARATIONS
Unless otherwise stated, all service and mainte-
nance must be carried out on a stationary machine
when the engine is not running.
Prevent the machine from rolling by al-
ways applying the parking brake.
Prevent unintentional starting of the
engine by always stopping the engine,
disconnecting the spark plug cable
from the spark plug and earthing it.
Disconnect the negative cable from the
battery.
CLEANING
To reduce the risk of fire, keep the en-
gine, silencer/catalytic converter, bat-
tery and fuel tank free from grass,
leaves and oil.
To reduce the risk of fire, regularly
check the machine for oil and/or fuel
leakage.
When washing the machine with water under high
pressure, do not point the jet directly at the trans-
mission.
Do not point jets of water directly at the engine.
48
ENGLISH
Use a brush or compressed air in order to clean it.

ENGINE OIL

(Master - Senator - President)
Change engine oil the first time after 5 hours of op-
eration, and subsequently after every 50 hours of
operation or once a season.
Change the oil more often (after 25 hours of oper-
ation or at least once a season) if the engine has to
operate under demanding conditions or if the am-
bient temperature is high.
Change oil when the engine is warm. Always use
a good grade of oil (service grade SF, SG or SH).
The engine oil may be very hot if it is
drained off directly after the engine is
shut off. So allow the engine to cool a
few minutes before draining the oil.
Unscrew the oil drain plug (fig. 9). It is situated on
the left of the engine (machine viewed from the
rear).
Collect the oil in a collection vessel. Then take
the oil to a recycling station. Do not allow oil to
get on the V-belts.
Screw in the oil drain plug.
Remove the dipstick and fill up with new oil to the
"FULL" mark.
Oil capacity: 1.4 litres
Oil type, summer (> 4ºC): SAE-30
(SAE 10W-30 can also be used. However, oil con-
sumption may increase somewhat if 10W-30 is
used. Therefore, check the oil level more regularly
if you use this type of oil).
Oil type, winter (< 4ºC): SAE 5W-30
(if this oil is not available, use SAE 10W-30).
Use oil without any additives.
Do not fill with too much oil. This can cause the
engine to overheat.
ENGINE OIL (Royal)
Change the oil for the first time after 20 hours of
operation (or during the first month), and then after
every 100 hours of operation or once every 6
months.
Change oil when the engine is warm. Always use
a good grade of oil (service grade SF, SG or SH).