Mobicool MCF 32 Guía Rápida página 10

Safety instructions
• If the device is left empty for long periods:
– Switch off the device.
– Defrost the device.
– Clean and dry the device.
– Leave the lid open to prevent mold developing within the device.
A
NOTICE!
Damage hazard
• Check that the voltage specification on the data plate corresponds to that of
the energy supply.
• Only connect the cooling device as follows:
– With the DC connection cable to a DC power supply in the vehicle
– Or with the AC connection cable to an AC power supply
• Never pull the plug out of the socket by the cable.
• If the cooling device is connected to a DC outlet, disconnect the cooling device
and other power consuming devices from the battery before connecting a
quick charging device.
• If the cooling device is connected to a DC outlet, disconnect the cooling device
or switch it off when you turn off the engine. Otherwise you may discharge the
battery.
• The cooling device is not suitable for transporting caustic materials or materi-
als containing solvents.
• The insulation of the cooling device contains flammable cyclopentane and
requires special disposal procedures. Deliver the cooling device at the end of
its life-cycle to an appropriate recycling center.
• Do not use electrical devices inside the cooling device unless they are
recommended by the manufacturer for the purpose.
• Do not place the cooling device near naked flames or other heat sources
(heaters, direct sunlight, gas ovens etc.).
• Risk of overheating!
Ensure at all times that there is a minimum of 50 mm ventilation on all four
sides of the cooling device. Keep the ventilation area free of any objects that
could restrict the air flow to the cooling components.
Do not place the cooling device in closed compartments or areas with none or
minimal air flow.
• Ensure that the ventilation openings are not covered.
• Do not fill the inner container with ice or fluids.
• Never immerse the cooling device in water.
• Protect the cooling device and cables against heat and moisture.
• The device shall not to be exposed to rain.
10
MCF32, MCF40, MCF60, FR40 AC/DC
EN