Publicidad
Idiomas disponibles
Idiomas disponibles
6. How to Use Juicer
11
01 Pull the lever on the inside of the hopper handle to open the hopper cover.
① The hopper cover opens when pulling the lever on the inside of the hopper handle. Insertion of an excessive
amount of ingredients may put too much strain on the product.
02 Add ingredients only up to the limit mark of the hopper.
① For soft ingredients, mix them with other ingredients for extraction.
② When extracting a large amount, frequently empty the chamber and pulp container.
03 Close the hopper cover and keep the juice cap open.
① Before turning the extraction dial, place the juice container first.
② The juice may flow backward into the hopper if the juice cap is closed during extraction.
If the juice does not come out even after opening the juice cap, open the hopper cover and empty the contents.
04 Press the [START/STOP] button to start operation.
① If the screw stops during operation, the product automatically rotates in reverse and then goes into a
normal operation. But, if the power is unstable, the reverse rotation may not work automatically. In such
a case, press the [START/STOP] button for over 1 second to activate a reverse rotation and then press the
[START/STOP] button again briefly to activate.
② A timer, which automatically stops after about 5 minutes from the start of operation, is set. If the [START/
STOP] button is controlled during operation or the hopper cover is opened and then closed, which pauses
and then restarts the machine, the timer is reset to 5 minutes again.
05 To add more ingredients during operation, use the additional inlet or open the hopper cover.
① When the hopper cover is opened, the operation stops.
② Do not use anything other than the designated pusher.
③ In case the screw spins but the ingredients fail to be ground in the hopper during extraction, use the
pusher to press the ingredients down.
06 Frequently empty out the pulp container and juice container so that they are not filled up.
07 Let the machine operate for about 1 more minute after all ingredients go down in the hopper.
① It slowly presses and squeezes the ingredients so it takes some time until the last ingredient is juiced.
② Removing the remaining pulp by additionally operating the machine after extraction makes it more
convenient to detach the hopper and clean the parts.
08 Once the juicing and pulp removal are finished, press the [START/STOP] button to stop the machine.
① The machine stops 3 seconds after it is stopped by the [START/STOP] button.
09 Pour any remaining juice by tilting the chamber forward.
① For thickly concentrated juice made of tomatoes, etc., the juice may still remain in the chamber.
Note
The reverse rotation is a function that returns the ingredients upward. It only works while the [START/
STOP] button is pressed and, once you lift your finger from the button, the screw stops rotating. After
the screw is completely stopped after a reverse rotation, press the [START/STOP] button briefly to start
the operation again. When operating the extraction or reverse rotation function, make sure to press the
[START/STOP] button after the screw stops moving completely. If the machine does not work even after
following the above steps, pull out the power cord from the outlet, detach the chamber set, wash it and
use it again. Due to its characteristics, the motor will not stop at once but, instead, continue to spin slowly
in the direction of operation before coming to a complete stop.
Publicidad
