10. How To Clean Juicer - HUROM M100 Serie Manual De Instrucciones

10. How to Clean Juicer

16
After the product stops operating completely, pull out
the power cord with dry hands. Even after the product
is stopped, the motor will slowly come to a stop so,
after the operation stops completely, wait about 3
seconds before detaching the chamber set.
01 Detach the chamber set from the product body. Turn
the hopper to open it and then sequentially pull each of
the parts to disassemble them.
02 Wash the parts with a cleaning brush under running
water.
03 Open the discharge cover and juice cap to clean the
chamber.
04 Wipe the product body with a damp towel or soft
cloth.
05 Detach and wash silicone packings after use. -
Residues may still be stuck. (hopper packing, juice cap
packing, extraction packing, seal packing, chamber
packing)
06 You can sterilize the parts by soaking them in warm
water diluted with baking soda, citric acid or vinegar.
※ Failure to clean the product immediately after use
may cause its stainless steel parts and other parts to
corrode or become discolored due to salt and pulp from
the ingredients. Also, contaminants may be dried up
and stuck inside, which makes it difficult to disassemble
and clean them and may also cause performance
impairment. Be sure to clean and air-dry it completely
immediately after use and store it in a clean place. For
long-term storage, use a cleaning brush to wash it. Do
not clean with boiling or high-temperature water or use
a cleansing sponge, steel sponge, abrasives and other
sharp cleaning tools. Do not place it in a dishwasher or
dish dryer.
※ If clean water is poured and shaken for washing, the
pulp will come off more easily.