Error Code - HUROM M100 Serie Manual De Instrucciones

12. Before Requesting for Repair
The screw stopped during
operation but a reverse
rotation does not work
automatically.
Juicing is automatically
terminated before the
5-minute timer ends.
The motor stops while the
blender is in operation.
Blender
Blender's grinding
operation does not work.
13. Error Code (common for juicer and blender)
Code
If an overcurrent flows through the
product, this error is generated to protect
Er01
the product.
If a high voltage is applied to the product,
this error is generated to protect the
Er04
product.
1. If the automatic reverse rotation is
operated often during the juicer operation,
this error may be generated to protect the
product. (This is an operation to protect
the chamber in case hard ingredients
or ingredients unable to be juiced are
inserted.)
2. This error may be generated if the motor
fails to perform the initial activation while
Er06
there are too many ingredients in the
blender container.
3. This error may be generated if the
overloading on the motor leads to activation
of the temperature protection device.
4. This error may be generated if the
sensor that detects the motor's operation is
broken.
This error may be generated if the jog dial
or the [START/STOP] button is controlled
└┘
while there is no juicer chamber set or
blender container on the product body.
If the power is unstable, the product may not perform a reverse rotation
automatically. Refer to Page 11 of the manual and activate a reverse
rotation.
It is a function that automatically shuts down to protect the product in case
the automatic reverse rotation is operated often during juicing. This may
occur if it is impossible to extract or if uncut ingredients are added.
Please refer to Page 14 of the manual for the instructions on each
ingredient and insert the ingredients accordingly.
If the blender is overloaded, the motor may stop. Turn off the power and
remove the ingredients that cause the overloading or let it rest for about 30
minutes.
The machine may stop operating if there are too many ingredients or the
ingredients are too thick.
Adjust the amount and size of the ingredients and then operate the machine
again.
In case dry ingredients are used in a large volume, add more liquid before
operation.
Root cause Actions to take
Stop operating the product and restart it
after a few minutes.
If the same problem continues to occur,
please contact the HUROM After-sales
Service Center.
Stop operating the product and restart it
after a few minutes.
If the same problem continues to occur,
please contact the HUROM After-sales
Service Center.
1. Stop operating the product, check and
remove the contents inside the juicer's
chamber set, and then restart it.
2. Stop operating the product and reduce
the amount of contents inside the blender
container or raise the motor speed at the
initial operation.
3. If the motor stops due to overloading,
let it rest for about 30 minutes before
operating the machine again.
4. If the same problem continues to occur,
please contact the HUROM After-sales
Service Center.
Install the juicer or blender container on
the product body before use.
If the same problem continues to occur,
please contact the HUROM After-sales
Service Center.
19