Essential Information - CARLO GAVAZZI WM50 Manual De Instrucciones

Essential information

Managed measurements
Introduction
WM50 calculates and displays both main line and single channel and load measurements.
All measurements are displayed by UCS or via Modbus communications (Carlo Gavazzi VMU-C monitoring system or other data
acquisition system). Main line measurements are also available on screen.
Main line measurements
Note: the following values are available for all measurements: minimum, maximum, average (dmd) and maximum average (max
dmd). The available variables depend on the type of system set. Minimum and maximum values are calculated only considering
valid values and not out of range values.
Active energy/Reactive
energy
Totalizers
Current
Voltage
Total harmonic
distortion (THD)
18 WM50 - Instruction manual | 26/04/2022 | CARLO GAVAZZI Controls SpA
Total, partial and by tariff.
Imported
l
Exported
l
Up to three totalizers.
Gas
l
Cold water
l
Hot water
l
Heat
l
Protection trips
l
Neutral
l
Phase
l
System
l
Phase-phase
l
Phase-neutral
l
System
l
Up to 32 nd harmonic. Total,
even and odd.
Phase current
l
Phase-phase voltage
l
Phase-neutral voltage
l
Note
: even single harmonics from
UCS.
Total demand distortion
(TDD)
Power
Power factor
Frequency
Voltage asymmetry
Note: main line energy meter values may differ from the total
of single channel energy meters. This is because they are
measured with a different precision class (main line: class
0.5S, channels: class 2).
Phase current
Reactive, active, apparent.
Phase
l
System
l
Phase
l
System
l
System
Phase-phase
l
Phase-neutral
l