Fitting The Parking Aid; Connecting The Parking Aid - Waeco MagicWatch MWE 910 Instrucciones De Montaje Y De Uso

MagicWatch MWE910, 900, 900F
5

Fitting the parking aid

See fig. 7 to fig. 0
NOTICE! Risk of malfunction
A
Align and attach the sensor holders correctly. Otherwise the correct
function of the parking aid cannot be ensured.
The sensor holders must be attached with the retaining tabs point-
ing up and down.
CAUTION! Risk of paint damage!
A
 The ambient temperature may not fall below 18 °C when punch-
ing or drilling.
 We recommend using a punching tool.
Supplementary to fig. 7 A
➤ Drill the holes according to the selected sensor holder.
Supplementary to fig. 7 B
➤ Make sure that you do not tilt the punching tool when operating.
Supplementary to fig. 8
➤ Clean the adhesive surface on the inner side of the bumper with a primer.
6

Connecting the parking aid

NOTE
I
 MWE910/900: On some vehicles, the reversing light only works
when the ignition is switched on. In this case, you must switch
on the ignition in order to identify the positive and earth wires.
 MWE910/900F: You can set a switch-off time for the front sen-
sors if you are unable to get a speedometer signal for the front
sensor control electronics (neither an analogue connection from
the speedometer nor digital via the CAN bus such as CBI150).
The front sensors are activated by switching on the ignition and
deactivated after the set time (parameter 12).
A MWS-910 switch (accessory) can also be used to activate the
front sensors.
EN
Fitting the parking aid
25