Publicidad
Idiomas disponibles
Idiomas disponibles
1.4 Quick Cooling
1) When the Quick Cooling function is enabled, the compartment temperature will be controlled at 2℃ automatically.
Cooling down the compartment temperature in a rapid manner is beneficial to the prevention of food nutrition against lost
and the preservation of freshness.
Under the Quick Cooling mode, the temperature is subject to no change.
The Quick-Cooling function can be enabled only in the fridge mode.
2) Enabling the Quick Cooling function
In the fridge mode, press the Function key to select Quick Cooling until the corresponding icon gets flickering, and
then press the OK/Lock key within 5s for confirmation. If the OK/Lock key is not pressed within 5s, the setting will be
invalidated.
3) Exiting the Quick Cooling function
Under the Quick Cooling mode, press the Function key to select Quick Cooling until the corresponding icon gets
flickering, and then press the OK/Lock key for confirmation, the Quick Cooling function will get exited.
1.5 Child Lock
1） When the Child Lock function is enabled, the temperature and function are subjected to no change to prevent
maloperation.
2） In case of no key operation within 3 minutes, the Child Lock function will be enabled automatically.
3） Enabling/exiting the Child Lock function manually
Press and hold down the OK/Lock for 3s, then the Child Lock function can be enabled/disabled.
1.6 Door open alarm
If any door is open for more than 3 minutes, buzzer alarms will be continuously issued, which can be stopped when any
key is pressed, but will be restored after 3 minutes if the door keeps open. The alarms will not be lifted until the door is
closed.
1.7 Power-cut memory
In case of power failure, the refrigerator will maintain the operating state before power failure when power supply is
restored.
1.8 Power-on delay
In order to protect the refrigerator compressor from being damaged in the case of short-time power failure (i.e., less
than 5 minutes), the compressor will not be started immediately after it is powered on.
1.9 Over-temperature alarm (only after power outage)
When the refrigerator system is powered on, if it is set in the freezer mode and the compartment temperature is higher
than -10℃, digits of temperature get flickering on the display. The temperature at which the system is energized can be
displayed when any key is pressed, and the normal display will be restored when any key is pressed again or after 5s.
1.10 Fault alarm
In case E0, E1, E2, EH, or EC is displayed on the operation panel, it indicates fault with the refrigerator. Please contact
the aftersales person for visiting service in such case.
XII.
Instructions for food storage
Precautions for use
The appliance might not operate consistently (there is possibility of defrosting or temperature becoming too warm
in the frozen food compartment) when sited for an extended period of time below the cold limit of the
temperature range for which the refrigerating appliance is designed
The information of climate type of the appliance is provided on the rating plate.
The internal temperature could be affected by such factors as the location of refrigerating appliance,
ambient temperature, and frequency of door open, etc., and if appropriate, a warning that setting of any
temperature control device might have to be varied to allow for these factors should be made.
Effervescent drinks should not be stored in the freezer compartment or the low-temperature compartment, and some
products such as water ices should not be consumed too cold.
Publicidad
