Publicidad
ASSembLy
Step 1: (fig. 1)
1. Assemble the flow plate (K) to the hopper assembly (AB)
as shown below.
Fig. 1
AB
K
Step 2: (fig. 2)
1. Position the flow plate (K) and slide gate bracket as
shown below.
Fig. 2
Step 3: (fig. 3)
1. Insert the tab on the slide gate bracket into the notch in
the flow plate (K).
Fig. 3
Step 4: (fig. 4)
1. NOTE: Make sure to insert the axle as shown below.
The right side has a hole at the very end, and the left
side has a hole further away from the end. Attach the
gearbox (AH) to the axle (AG) by inserting the axle
through the frame (AA) and gearbox and through the
other side of the frame. Secure with a 1-1/2" cotter pin
(S) by bending the ends out.
Fig. 4
K
LEFT
AA
RIGHT
AH
S
AG
ENglISh
3
Publicidad
