Preparation For Operation - Steinberg Systems SBS-MD-24 Manual De Instrucciones

3. Numerical discrimination value
4. Digital Object Identification
5. Battery level indicator
6. Sensitivity, SENS, and object depth indicators
3.2.

Preparation for operation

ASSEMBLY OF THE UNIT
1. Open the package and remove all components.
2. Connect the detector's probe (1) to the lower stem (4) and then tighten the
probe fixing screw (2).
2. Press the lock on the lower stem (5) and slide it into the middle stem (8). The
lock must be visible in one of the holes (7).
3. Press the lock in the middle stem and slide it into the upper stem (11). The lock
must be visible in one of the holes.
4. Adjust the length of the stem so that you can comfortably stand upright
holding the detector with the probe parallel to the ground. The other arm
should be relaxed, placed freely along the body. Tighten the locking nut on the
middle stem (6) counterclockwise.
5. Attach the control panel (9) to the upper stem (11). Direct the tabs on the
control panel into the special holes on the middle stem and then slide the
control panel in the direction of the arrows on the stem.
Tighten the screws holding the control panel (10) securely.