Steinberg Systems SBS-MD-24 Manual De Instrucciones página 26

6. Wrap the cable (3) around the stem and insert the cable plug into the 5-pin
socket (on the back of the control panel).
7. Check that the stem length is correct. Stand upright holding the detector with
the probe parallel to the ground at a height of 1-5 cm. The other arm should
be relaxed, placed freely along the body.
CAUTION!
bolts!
CAUTION!
orientation. Do not force the plug or pull the cable - damage may result.
INSTALLING BATTERIES (batteries not included):
1. Turn off the unit before installing the batteries.
2. Slide both battery covers in the direction indicated by the arrow.
3. Insert two 9V alkaline batteries into the battery compartment according to the
polarity markings inside the unit.
4. Close the battery compartment by sliding the cover back.
5. Now the unit is ready for operation.
6. Replace the batteries when the battery level icon is not filled with color.
CAUTION!
CAUTION!
the batteries! Batteries can be damaged and lead to destruction of electronic
components.
CAUTION!
Do not use excessive force or tools to tighten the clamping nuts and
The cable plug must be placed in the socket in the correct
Do not mix different types of batteries, or old and used batteries.
If the detector is not going to be used for a week or more, remove
Use only new batteries of the required size and voltage!