Publicidad
Idiomas disponibles
Idiomas disponibles
not cover any cleaning operations to which the
operative components may be subjected, such
as clogged nozzles and filter blocked due to
limestones. This pressure cleaner is intended
to be used for domestic and hobby work: the
warranty does not cover any other different
kind of use.
DISPOSAL (WEEE)
As the owner of electrical or electronic
equipment, the law (in accordance with the
EU Directive 2012/19/EU on waste from elec-
trical and electronic equipment and the na-
tional laws of the EU Member States that
have implemented this Directive) prohibits you
from disposing of this product or its electrical / elec-
tronic accessories as municipal solid waste and
obliges you to make use of the appropriate waste
collection facilities.The product can be disposed of
TROUBLESHOOTING
FAULT
PROBABLE CAUSE
1. The pump does
1. The plug is not properly connected to the
not start when the
socket.
switch is
2. The electrical socket is not working.
pressed.
3. The mains voltage is insufficient.
4. The gauge of the electrical power lead is too
small.
5. The pump has cut out.
2. The machine starts,
6. Pump, hoses or accessories frozen.
but no water comes
7. No water supply.
out.
8. Water filter fouled.
9. Nozzle fouled.
3. The pump runs but
10. Insufficient water.
pressurisation does
11. Suction filter fouled.
not
12. Pressure regulator valve (if fitted) on mini-
take place.
mum pressure setting.
13. Lance nozzle worn.
14. Suction or delivery valves fouled or worn.
4. Uneven working
15. Lance nozzle fouled or dirty.
pressure.
16. Air in intake water.
17. Suction filter fouled.
18. Suction or delivery valves fouled or worn.
19. Gaskets worn.
20. Pressure regulator valve gaskets worn.
by returning it to the distributor when a new prod-
uct is purchased. The new product must be equiva-
lent to that being disposed of. Disposing of the
product in the environment can cause great harm to
the environment itself and human health. The sym-
bol in the figure indicates the urban waste contain-
ers and it is strictly prohibited to dispose of the
equipment in these containers. Non-compliance
with the regulations stipulated in the Directive
2012/19/EU and the decrees implemented in the
various EU Member States is administratively pun-
ishable.
REPAIR
1. Connect the plug to the power socket
correctly.
2. Have the electrical socket checked.
3. Check that the system is suitable.
4. Refer to the section detailing the electrical
connection.
5. Turn the switch to ON while keeping the gun
lever pressed; if the problem persists contact an
authorised service centre.
6. Allow the pump and hoses to thaw.
7. Connect the machine to the water supply
system and turn on the tap.
8. Remove and clean the filter (see "MAINTE-
NANCE" section).
9. Remove the lance from the gun and clean the
nozzle with the pin provided.
10. Check that the delivery rate is at least 12 l/
min.
11. Remove and clean the filter (see "MAINTE-
NANCE" section).
12. Increase the pressure by turning the
handgrip.
13. Replace the lance.
14. Contact an authorised service centre.
15. Remove the lance from the gun and clean
the nozzle with the pin provided.
16. Supply the machine with water correctly.
17. Remove and clean the filter (see "MAINTE-
NANCE" section).
18. Contact an authorised service centre.
19. Contact an authorised service centre.
20. Contact an authorised service centre.
EN
21
Publicidad
