Publicidad
Idiomas disponibles
Idiomas disponibles
Note: Tools required: medium phillips screw driver, 5/16" open end or adjustable wrench.
UNPACKING
1. Remove the heater from the carton.
2. Remove all packing materials applied to the heater for shipment.
3. Remove all items from the carton.
4. Check the heater for shipping damage. If heater is damaged,Contact
your customer service.
ASSEMBLY FOR MH-0075-RM10 MODEL
1. Align the holes in the upper housing with the 2 mounting holes in
the handle as shown.
2. Secure handle through holes provided.
ASSEMBLY FOR MH-0135-RM10,
MH-0190-RM10 MODELS
These models come complete with wheels and
handles. Wheels, handles and mounting hard-
ware are located in the shipping carton.
1. Loosely secure the Axle Bracket to the Wheel
Support Frame.
2. Slide the axle through the Axle Bracket.
3. Install the wheels on the axle, with the valve
facing outward.
4. Place the flat washers and fastening nut on
the axle ends.
5. Tighten the Axle Brackets.
6. Position the Height Adjustment Pipe to align
the hole as shown.
7. Insert and tighten the bolt (M8).
CAUTION: DO NOT OPERATE HEATER WITHOUT SUPPORT FRAME FULLY ASSEMBLED TO
TANK.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE CONNECTED TO A FUEL
SOURCE.
GUARD ASSEMBLY (FOR CANADA ONLY)
TO ATTACH THE GUARD
1. Remove the screws from the upper shell and set aside.
2. Align the holes in the Guard with the holes in the upper shell as
shown.
3. Secure the guard to the upper shell by inserting and tightening
the screws.
TO ATTACH THE INTERCEPTOR
1. Remove the screws from the lower shell and set aside.
2. Align the holes in the Interceptor with the holes in the lower shell
as shown.
3. Secure the Interceptor to the lower shell by inserting and
tightening the screws.
Kerosene Portable Heaters Manual
ASSEMBLY
Handle
Wheel
Support
Frame
Wheel
Models 135K / 1 90K
Interception
Interception
Handle
Handle Installation 75K
Axle
Guard
Guard
Screw
Air
Inlet
Fuel
Tank
Flange
11
Publicidad
