Maintenance; Before Operating This Heater; Air Intake Filter; Air Output Filter And Lint Filter - Mi-T-M MH-0075-RM10 Manual Del Operador

WARNING: DO NOT TAMPER WITH THE HEATER. HAVE A COMPETENT SERVICEMAN MAKE ANY
NECESSARY ADJUSTMENTS OR REPAIRS.
WARNING: DISCONNECT THE HEATER FROM ITS POWER SOURCE BEFORE SERVICING.
WARNING: HOT WHILE IN OPERATION. DO NOT TOUCH. ALLOW HEATER TO COOL BEFORE
SERVICING.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE CONNECTED TO A FUEL
SOURCE.

BEFORE OPERATING THIS HEATER

Visually inspect for damage. Some parts may have become loose or were damaged from handling. Be cer-
tain the fuel cap is securely fastened and check that the drain plug (if applicable for your model) is installed
properly. Replace or repair any damaged parts before operating this heater. USE ORIGINAL EQUIPMENT
REPLACEMENT PARTS. Use of third party or other alternate components will void the warranty and may
cause unsafe operating conditions. If you need replacement parts or require assistance, contact customer
service.

AIR INTAKE FILTER

Dirty Intake Filters can cause an imbalance in the fuel-to-air mixture, resulting in rough starting, poor com-
bustion and odors. Never operate a heater without the filters in place. Remove and wash the intake with a
mild detergent and water. Thoroughly dry and replace the filter. Clean the filters every 500 hours as needed.
Air Out Put Filter
End Filter Cover
Lint Filter

AIR OUTPUT FILTER AND LINT FILTER

The Output and the Lint Filter are not designed to be cleaned and reused. Do not wash these filters. Replace
dirty filters at the start of each season.

REPLACING AIR FILTERS

1. Remove Upper Shell and Fan Guard.
2. Remove End Filter Cover screws using a medium Phillips screwdriver.
3. Remove End Filter Cover.
4. Replace the Air Intake Filter, Air Output Filter, and Lint Filter.
5. Reinstall End Filter Cover.
6. Reinstall Fan Guard and Upper Shell.
14

MAINTENANCE

Intake Filter
Kerosene Portable Heaters Manual